ANTF0472E

Explanation
The FlashCopy® Withdraw
request was issued with the REMOTE(YES) or OPENDVCS(YES) keyword.
The REMOTE or OPEN FlashCopy TARGET
device cannot be accessed as the FlashCopy Withdraw
target. An error occurred while attempting to access the REMOTE target
device. Any of the following conditions can cause this error.
The target serial number is not the same as
the Source serial number (not the same as the PPRC Secondary device
if REMOTE(YES) was specified).
The target lss is not valid (for the PPRC Secondary
subsystem if REMOTE(YES) was specified).
The target cca or lun is
not valid (for the PPRC Secondary subsystem if REMOTE(YES) was specified).
If REMOTE(YES) was specified and the Target device is a CKD device,
the SSID ssid is not the same as the PPRC Secondary device ssid.

System action
The command is rejected.

System programmer response
If REMOTE(YES) was specified and OPENDVCS(YES)
was not specified, use the PPRC CQUERY command to determine the status
of the DEVN device. If the DEVN device is a PPRC Primary volume, make
sure the PPRC Secondary device information is the same as the REMOTE FlashCopy SOURCE device information.
If OPENDVCS(YES) was specified and REMOTE(YES) was not specified,
use PPRC CQUERY  with OPENDVCS(YES) to query the source device and
the target device.  Verify that the target is valid for the source
device specified. After making any changes or corrections, resubmit
the FlashCopy Withdraw
request.

Source
ESS FlashCopy