The model of the total system enqueue request rate has detected that the request rate is lower than expected based on the previous history of this system. An unusually low enqueue request rate can indicate an impending system hang. The enqueue request rate is the ratio of the arrivals and the CPU used in the last collection interval. The next model will occur at nextmodeltime. The prediction used in the comparison was modeled at lastsuccmodeltime.
The WTOTYPE of the check has been changed to NONE so that subsequent runs of this check will not produce an operator message until new data is available. The check will collect data and model new predictions at the next collection interval. After modeling is successful, if the current setting of WTOTYPE is still NONE, the previous setting will be restored so that the check will issue future exceptions based on that setting.
Examine data from Runtime Diagnostics to determine the source of the lower than expected enqueue request rate.
See operator response to determine the cause of the lower than expected enqueue request rate.
See operator response to determine the cause of the lower than expected enqueue request rate.
Predictive Failure Analysis (SCPFA)
AIRHMCHK
N/A
N/A
This message should trigger an alert to system programmers / operator to determine the cause of the lower than expected enqueue request rate.
None.
The total system enqueue request rate is lower than expected and may
indicate a system problem.