722

Explanation
One of the following output limits was exceeded: The output limit specified by the OUTLIM keyword on the SYSOUT
DD statement
The job output limit specified in the LINES and CARDS parameters
of the JES2 JOBPARM statement
The job output limit specified in the BYTES, CARDS, LINES, and
PAGES parameters on the STANDARDS initialization statement or the
JES3 MAIN statement

System action
The system ends processing of the job step.

Programmer response
Check for input/output (I/O) loops. Verify
that the parameter value does not conflict with any installation requirements.
If no errors are found, increase the value in the statement. Then
run the job again.

Source
JES