036

Explanation
The error occurred during processing of a BISAM
or QISAM OPEN macro instruction.
The control program found that
no space was allocated on a direct access device as the prime area
for the data set: In QISAM load mode, during data set generation, the SPACE parameter
of the DD statement did not specify a primary quantity.
The data set control block (DSCB) for the data set was incorrectly
modified by the problem program.

System programmer response
If the error recurs and the program
is not in error, look at the messages in the job log for more information.
Search problem reporting data bases for a fix for the problem. If
no fix exists, contact the IBM® Support
Center. Provide the JCL and the program listing for the job.

Programmer response
In the first case, the data set should be
dumped sequentially and recreated using QISAM load mode.  The job
should be restarted with a primary quantity specified in the SPACE
parameter of the DD statement.  If the prime area is to span more
than one volume, the number of volumes and the number of units required
should be specified.
In the second case, verify that the data
set control block was not incorrectly modified by the problem program.
 After making corrections, reassemble the program and run the job
step again.

Source
DFSMSdfp