Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
Setting up a periodic display of outstanding requests z/OS MVS Planning: Operations SA23-1390-00 |
|
If your system includes JES2, you can have the system periodically display outstanding requests so that you always know how many there are. You can set up such a periodic display through the JES2 automatic
command facility, telling JES2 to issue a command at a defined interval. (The
minimum time interval you can specify is 30 seconds.) You must use
the $TA JES2 command to define both the command you want issued and
the number of seconds in the
interval between commands. To cause JES2 to issue a DISPLAY R command
every 60 seconds and to direct the command output to display area
B of CONSD, issue the following command:
Note: Put this command in the JES2 initialization data set so that
it is issued automatically once JES2 is initialized.
You use the $ZA JES2 command to temporarily stop
JES2 from issuing the defined commands. You use the $SA command to
cause JES2 to resume issuing the defined commands. Use the $CA command
to cancel both the defined commands and time interval:
where xxxx is the ID of the periodic display. |
Copyright IBM Corporation 1990, 2014
|