Use the SETPROG command for:
- Updating the APF List (SETPROG APF)
- Change the format of the authorized program facility (APF) list from static to dynamic, or dynamic to static
- Add a library to a dynamic APF list
- Delete a library from a dynamic APF list.
- Updating Dynamic Exits (SETPROG EXIT)
- Add an exit routine to an exit
- Replace an exit routine for an exit
- Change the state of an exit routine
- Delete an exit routine from an exit
- Undefine an implicitly-defined exit
- Change the attributes of an exit
- Updating LNKLST Concatenations (SETPROG LNKLST)
- Define a LNKLST set of data sets for the LNKLST concatenation
- Add data sets to or delete data sets from the LNKLST set
- Remove the definition of a LNKLST set from the system
- Test for the location of a specific module in the LNKLST concatenation
- Activate a LNKLST set as the LNKLST concatenation for the system
- Update an address space for jobs to use a LNKLST set.
- Managing Dynamic LPA Content (SETPROG LPA)
- Specify modules to add to the LPA after IPL
- Specify modules to delete from the LPA after IPL
- Specify the minimum amount of CSA storage that must remain available after an ADD operation.
- Enabling protection of REFR programs (SETPROG REFRPROT)
- Disabling protection of REFR programs (SETPROG NOREFRPROT)
Enabling tracking of directed load modules (SETPROG
TRACKDIRLOAD)
- Disabling tracking of directed load modules (SETPROG
NOTRACKDIRLOAD)
Each subcommand of SETPROG (for example, SETPROG LNKLST,DEFINE) has a direct analog in the PROGxx parmlib member (such as the LNKLST DEFINE statement) activated by SET PROG=xx. You will get the same result whether you activate the function by SETPROG or by SET PROG=xx.