Subparameter definition for JES3 systems

ANYLOCAL

Indicates any local device.

'IP:ipaddr' | 'nodename.IP:ipaddr'

Identifies a TCP/IP routing designation, where ipaddr can be any printable character string of from 1 to 124 characters. The entire parameter list is limited to 127 characters, and it must be enclosed in single quotation marks.

device-name

Identifies a local device by a symbolic name defined by the installation during JES3 initialization. device-name is 1 through 8 alphanumeric or national ($, #, @) characters.

group-name

Identifies a group of local devices, an individual remote station, or a group of remote stations by a symbolic name defined by the installation during JES3 initialization. group-name is 1 through 8 alphanumeric or national ($, #, @) characters.

nodename

Identifies a node by a symbolic name defined by the installation during JES3 initialization. The node is 1 through 8 alphanumeric or national ($, #, @) characters. If the node you specify is the same as the node you are working on, JES3 treats the output as though you had specified ANYLOCAL.

nodename.remote

Identifies a destination node and either a remote work station or VM userid at that node, as follows:

nodename: A symbolic name defined by the installation during JES3 initialization. The nodename is 1 through 8 alphanumeric or national ($, #, @) characters.
remote: A name for a remote work station. The name is 1 through 8 alphanumeric or national ($, #, @) characters and must be defined at the node. Enclose it in apostrophes when it contains special characters or begins with a number.