|
- ANYLOCAL
- Indicates any local device that is attached to the global processor.
- device-name
- Identifies a local device by a symbolic name defined by the
installation during JES3 initialization. device-name is 1 through
8 alphanumeric or national ($, #, @) characters.
- device-number
- Identifies a specific device by a 3-digit or 4-digit hexadecimal
number. Precede a 4-digit number with a slash (/). A 3-digit number
can be specified with or without a slash.
- group-name
- Identifies a group of local devices, an individual remote station,
or a group of remote stations by a symbolic name defined by the installation
during JES3 initialization. group-name is 1 through 8 alphanumeric
or national ($, #, @) characters.
- nodename
- Identifies a node by a symbolic name defined by the installation
during JES3 initialization. nodename is 1 through 8 alphanumeric
or national ($, #, @) characters. If the nodename you specify is the
same as the node you are working on, JES3 treats the output as though
you specified ANYLOCAL.
- (nodename,userid)
- Identifies a nodename and a TSO/E or VM userid at that nodename.
The nodename is a symbolic name defined by the installation during
initialization; node is 1 through 8 alphanumeric or national ($, #,
@) characters. The userid must be defined at the nodename; userid
for TSO/E is 1 through 7 alphanumeric or national ($, #, @) characters
and for VM is 1 through 8 alphanumeric or national ($, #, @) characters.
A
userid requires a nodename; therefore, code DEST=(nodename,userid).
You cannot code a userid without a node.
DEST=(nodename)
is valid with a writer-name subparameter in
the SYSOUT parameter: however, DEST=(nodename,userid) is not valid.
Therefore, you can code SYSOUT=(A,writer-name),DEST=(nodename).
- (nodename,devicename)
- Identifies a node by a symbolic name defined by the installation
during JES3 initialization. nodename and devicename are each 1 through
8 alphanumeric or national ($, #, @) characters. devicename identifies
a device by a symbolic name defined to that node by the installation
during JES3 initialization. devicename is 1 through 8 alphanumeric
or national ($, #, @) characters.
Use this form of the DEST parameter
to override the ORG parameter.
|