 |
- nodename.userid
- nodename:userid
- nodename/userid
- nodename(userid)
- Identifies a node and a TSO/E or VM userid at that node. The
nodename is a symbolic name defined by the installation during initialization;
nodename is 1 through 8 alphanumeric or national ($, #, @) characters.
The userid must be defined at the node; userid for TSO/E is 1 through
7 alphanumeric or national ($, #, @) characters and for VM is 1 through
8 alphanumeric or national ($, #, @) characters.
- userid
- Identifies a TSO/E or VM user. The userid for TSO/E is 1 through
7 alphanumeric or national ($, #, @) characters and for VM is 1 through
8 alphanumeric or national ($, #, @) characters. When you specify
only a userid, JES2 assumes that the userid is at the origin node.
The
userid may also be a valid remote ID in the form Rnnnn or a destid
for a remote. If the userid is specified as R1-R9999, JES2 assumes
the notify message is intended for a remote and not a userid. If the
remote is defined to the system or is less than the highest defined
remote for your system, the notify message is queued to the remote.
If the remote value is greater than the highest defined remote but
less than the maximum allowed remote, the notify message is discarded.
If the Rxxxx value specified is greater than R9999, JES2 considers
that a TSO/E userid and not a remote ID.
A valid remote ID
is only found when the node specification is for the local node. A
valid specification can be in the form of NxRy.
|
z/OS MVS JCL Reference
Copyright IBM Corporation 1990, 2014