Use the modify form of the EDTINFO macro to change parameters in the control parameter list that the system created through the list form of the macro.
The modify form of the EDTINFO macro is written as follows:
Syntax | Description |
---|---|
name | name: Symbol. Begin name in column 1. |
␢ | One or more blanks must precede EDTINFO. |
EDTINFO | |
␢ | One or more blanks must follow EDTINFO. |
RTNEDTLT | Note: If this function is specified, no other
functions can be requested.
|
,ELTPRI=eltpri | eltpri: RS-type address or register (2) - (12). |
,ELTSEC=eltsec | eltsec: RS-type address or register (2) - (12). |
,RETCODE=retcode | retcode: RX-type address or register (2) - (12). |
,RSNCODE=rsncode | rsncode: RX-type address or register (2) - (12). |
,MF=(M,list addr) | list addr: RX-type address or register (2) - (12). |
,MF=(M,list addr,COMPLETE) | Default: COMPLETE |
,MF=(M,list addr,NOCHECK) | |
The parameters are explained under the standard form of the EDTINFO macro with the following exceptions:
The list addr parameter specifies the address of the storage area for the parameter list.
COMPLETE specifies that the system is to check for required parameters and supply defaults for optional parameters that were not specified. NOCHECK specifies that the system does not check for required parameters and does not supply defaults for optional parameters that were not specified.