Perform the following steps to run ACS test cases.

1. Display the ACS Test Selection panel, as described in Creating ACS test cases.

   _______________________________________________________________

2. Supply values on the ACS Test Selection panel:

   Option

   Select option 3, Test.

   ACS Test Library

   Supply the library name.

   Press Enter to see the Test ACS Routines panel.

   _______________________________________________________________

3. Supply values on the Test ACS Routines panel to indicate which routines you want to test.

   ACS Test Library and Member

   These identify the data set and member that contain the test case. Specify an asterisk in the Member field to run all test cases in the partitioned data set library.

   Listing Data Set

   Specify a data set name to create a listing of the results of the testing. Leave this field blank to prevent the creation of a listing.

   _______________________________________________________________

4. Press Enter to test the routines. If you specified a listing data set, the results of the testing are displayed in the PDF Browse panel.

   After examining the results, issue the END command and specify on the ACS Output Listing Disposition whether or not to keep the output listing.