SETSMS command to alter the setting of BreakPointValue

You can use the SETSMS command to change the setting of BreakPointValue without having to re-IPL. This modified setting is in effect until the next IPL when it reverts to the value specified in the IGDSMSxx member of PARMLIB. To make the setting change permanent, you must alter the value in SYS1.PARMLIB.

The syntax of the operator command is:

 SETSMS BreakPointValue(0-65520)

Note: You cannot use the SETSMS command to alter the value inside any individual Storage Group. You must use the ALTER command in the ISMF Storage Group Application.