The first page of the Aggregate
Group Alter panel contains aggregate group alter attributes.
The SCDS Name and Aggregate Group Name fields are output fields that
contain the SCDS and aggregate group names you specified on the Aggregate
Group Application Selection panel. The Description field is an optional
field of 120 characters in which you can describe the aggregate group.
You can specify the following required attributes on the first
page of the Aggregate Group Alter panel:
- Number of Copies
- Specifies
the number of aggregate backup output files to be
altered. The valid values range from 1 to 15.
- Management Class Name
- Specifies
the management class name from which the aggregate
backup attributes are obtained. The valid values are 1 to 8 alphanumeric
characters (first character can not be a digit) or a blank.
The second page of the Aggregate Group Alter
panel contains the
selection data set names for the aggregate group. SCDS Name and Aggregate
Group Name are output fields that contain the SCDS and aggregate group
names you specified on the Aggregate Group Application Selection panel.
You can specify the following required attributes on the second
page of the Aggregate Group Alter panel:
- To Edit a Data Set, Specify Number
- Select the number of a selection or instruction
data set that
you want to edit. When you select a data set number, you can alter
the data set by invoking PDF Edit. The PDF edit screen is shown in Figure 1. See z/OS ISPF User's Guide Vol I for
more information on PDF Edit commands.
- Selection
Data Sets
- The name of the data set containing the
lists of data sets to
be included in the application backup. You can specify up to five
selection data set names. One data set name is required. If you want
to enter a fully qualified data set name, enclose the name in single
quotation marks. If you do not enclose the name in single quotation
marks, the TSO/E prefix is added to the name as the first high level
qualifier.
- Member Name
- The name of the data set member containing the lists
of data
sets to be included in the application backup if the selection data
set is partitioned. This name must be a valid TSO/E data set member
name. If the data set specified in the Selection Data Set Name field
is a partitioned data set, you must specify a valid member name. There
is no default.
- Instruction Data Set Name
- The name of the data set containing
instruction, commands, and
such, that are copied into the control file volume after the backup
control file. This data set can only be a sequential data set. You
must use a valid TSO/E data set name. The data set name, including
the TSO/E prefix, can be no more than 44 characters long. This is
an optional field and has no default.