Use the CHANGEDATASET TSO subcommand to update information about
data sets defined to DFSMSrmm.
- BLKCOUNT(number_of_blocks)
- Specifies number of data blocks used by the data set. The value
corresponds to that recorded in the data set's End of File label.
The minimum allowable decimal value is 0; the maximum allowable decimal
value is 4294967295. DFSMSrmm uses BLKCOUNT together with BLKSIZE
to calculate the data set's approximate size and the sum of all data
set sizes to set the volume usage.
- TOTALBLKCOUNT(count)
- Use this operand to add a block count for a complete tape data
set. The total block count is the sum of all block counts for all
volumes on which the data set resides. The minimum allowable decimal
value is 0. The maximum allowable decimal value is 18446744073709551615.
Note: When this operand is specified, the FORCE operand must also
be specified if DFSMSrmm has automatically recorded information about
the volume during O/C/EOV processing of a data set on the volume.
To use the FORCE operand, you must have CONTROL access to the STGADMIN.EDG.MASTER
security resource and UPDATE access to the STGADMIN.EDG.FORCE security
resource.