After completing the five pages of the Data Set Selection Entry
Panel, you are ready to generate the data set list. Press the ENTER
key. ISMF displays the data sets that meet your selection criteria,
as shown in Figure 1.
Figure 1. Generated
Data Set List Panel Panel List Dataset Utilities Scroll Help
------------------------------------------------------------------------------
DATA SET LIST
Command ===> Scroll ===> HALF
Entries 1-13 of 379
Enter Line Operators below: Data Columns 3-5 of 41
LINE ALLOC ALLOC % NOT
OPERATOR DATA SET NAME SPACE USED USED
---(1)---- ------------(2)------------ ---(3)--- ---(4)--- -(5)-
SYS1.ADFMAC1 --------- --------- ---
SYS1.BRODCAST --------- --------- ---
SYS1.CBRDBRM --------- --------- ---
SYS1.CHSLIB --------- --------- ---
SYS1.CLIST --------- --------- ---
SYS1.CMDLIB --------- --------- ---
SYS1.COB2LIB --------- --------- ---
SYS1.CSSLIB --------- --------- ---
SYS1.C90SPAC.PARMLIB --------- --------- ---
SYS1.C90SPAC.PROCLIB --------- --------- ---
SYS1.DAE --------- --------- ---
SYS1.DBBLIB --------- --------- ---
SYS1.DFPSHCDS.PLX2ACT. --------- --------- ---
VCV9PX1
Tips: - If you limit more than one field on a selection entry panel, the
list contains only the data sets meeting all of the
selection criteria. If ISMF cannot determine whether a data set meets
your selection criteria, the data set will be included in the list.
Values of dash (-), question mark (?), less-than (<), and greater-than
(>) always meet any selection criteria. If the exclusive list field
contained in the panel is specified, the list generated will contain
only the entries that meet the specified selection criteria. If this
field is not specified, the list will be inclusive. You can use the
filter command with the same selection criteria to exclude entries
with the special characters.
- When dealing with VSAM data sets, it is best to include all selection
criteria because some selection criteria are not in the cluster, causing
them to be excluded if exclusive is specified. Few of the line operators
will function only against clusters.
- To save a new list that you have generated, enter the SAVE command
followed by the name you want to use to identify the list. Read about Saving a Copy of the List.