Sending a Data Set to Another User

The SENDC CLIST is invoked as a line operator from the Data Set List Panel. SENDC performs the XMIT function on a single data set. When you invoke SENDC against a data set, the panel shown in Figure 1 is displayed.

Figure 1. Data Entry Panel for the SENDC CLIST

  Panel  Utilities  Help
 -------------------------------------------------------------------------------
                              XMIT OPTIONS PANEL

Optionally Specify One or More for USER10.HCD.TERM:

  Type of Xmit . . .          (1-entire data set, 2-member only, 3-a note)

  Data Set Name  . . USER10.HCD.TERM

  If Type of Xmit is '2', then Specify:
    Member Name . .           (1 to 8 character member name)

  To User Id  . . .
     At Node Id . .

  Enter "/" to select option      Log Xmit
                                  Notification



Use ENTER to Perform Xmit;
Use HELP Command for Help; Use END Command to Exit.

The data set name is already filled in when the panel is displayed. With the other fields on the panel you can:

Send the entire data set or just a member
Log the transaction
Receive notification that the data set or member was transmitted.

If the data set is not transmitted, the CLIST sets the history symbol prefix to a question mark (?) for the data set. You can use the MESSAGE line operator to review the result of the SENDC execution.