SNA RJE workstations

There are three ways that the operator can initiate an automatic terminal connection:

Entering the VTAM® LOGON command that identifies the VTAM application ID to JES2.
Specifying AUTOLOG=YES on the RMT(nnnn) definition to make the RJE workstation eligible for automatic logon whenever work exists.
This parameter causes JES2 to connect to an RJE workstation when SYSOUT is queued for processing.
Entering the $S RMT(nnnn) command to force a connection whether or not any work exists.
This command starts the JES2/VTAM interface, which allows JES2 to begin processing logons from the RJE workstations and terminals through the following command:
```
$S LGN(2)
```

If you use either method 2 or 3, you must also specify the logical unit name (LUNAME=) on the RMT(nnnn) statement, $ADD RMT(nnnn) command, or $T RMT(nnnn) command.