Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
Considerations for started tasks and TSO LOGONs z/OS JES2 Initialization and Tuning Guide SA32-0991-00 |
|
Output limits for TSO/E transmits can be set by TSO/E using the
TSO/E OUTLIM= parameter. JES2 also sets a limit internally. When
SYSOUT is transmitted in the foreground for started tasks and TSO/E
LOGONs, the member uses the lower of these two limits. JES2 sets the
following output limits for started tasks and TSO LOGONs:
An installation can change the limits for started tasks or TSO LOGONs by using JES2 Exit 20 to change the limit for each particular started task or TSO LOGONs The limit for TSO/E transmits which are specified thorough the OUTLIM parameter, should not be greater than the limit JES2 sets for punches or a X'722' abend will occur. See z/OS TSO/E Customization for information about limiting the TSO/E TRANSMIT command. |
Copyright IBM Corporation 1990, 2014
|