RCPT TO command: Specify the recipients of the mail

z/OS Communications Server: IP User's Guide and Commands

Previous topic | Next topic | Contents | Contact z/OS | Library | PDF

RCPT TO command: Specify the recipients of the mail

z/OS Communications Server: IP User's Guide and Commands
SC27-3662-00

Purpose

Use the RCPT TO command to specify mail recipients.

Restrictions:

A maximum of 2000 RCPT TO commands can be processed on a single note. If you have more than 2000 RCPT commands in your batch job, only the first 2000 RCPT commands are processed; the remainder are ignored.
You must issue a MAIL FROM command before you can issue an RCPT TO command.

Format


>>-RCPT TO:--<recipient_path_address>--------------------------><

Parameters

recipient_path_address: Specifies the full path address of the mail recipient.

Requirement: The less than (<) and greater than (>) symbols that surround the recipient_path_address parameter in the syntax diagram are required.

Go to the previous page

Go to the next page

Notices | Terms of use | Support | Contact z/OS | zFavorites

Copyright IBM Corporation 1990, 2013

This information center is Built on Eclipse™ ( www.eclipse.org ).