Parameters: PURGE = purge,PREFIX = prefix,
IPV6=ipv6, SECLABEL = seclabel
Explanation
This message is a continuation of EZA4403I or
EZA4404I. It indicates the values that have been specified for the
parameters of the RXSERVE cataloged procedure.
- purge
- The values for purge are Y or N. Y indicates
the job output from the jobs submitted by the server should be purged
immediately after the job execution and N indicates that the
job output will be held in the output queue.
- prefix
- A four-character value to be used as the first four
characters in the jobname of the jobs that are submitted by the server.
The remaining characters of the jobname are a sequential number between
1 and 9999.
- ipv6
- The values for ipv6 are Y or N. If N
is specified, RXSERVE will not attempt to communicate over an IPv6
network. Only connections from IPv4 clients will be accepted. If
this parameter is not specified or Y is specified, RXSERVE will attempt
to communicate over an IPv6 network.
- seclabel
- The values for seclabel are Y or N. If this parameter is not specified
or N is specified, RXSERVE does not attempt to add a security label
to the job card. If Y is specified, RXSERVE adds a security label
(if one exists) to the job card following the message class parameter.
For information about using the remote execution server in an MLS
environment, see the section on preparing for TCP/IP networking in
a multilevel security environment in z/OS Communications Server: IP Configuration
Guide.
System action
Operator response
System programmer response
Module
Procedure name
process_options