EZA2117I

Client SBSENDEOL must be CRLF for stream mode restart of
put
Explanation
 This message is displayed when the SRESTART PUT
subcommand is issued while  SBSENDEOL is not set to CRLF.  The client
cannot reliably restart a PUT operation unless the SBSENDEOL setting
was CRLF during the interrupted PUT or APPEND subcommand.   Therefore,
SRESTART PUT is disabled for the remainder of  this FTP login session.
   See  the information about the SBSENDEOL
statement in the z/OS Communications Server: IP Configuration
Reference for more information  about SBSENDEOL settings.

System action
 The FTP client stops processing the SRESTART
PUT subcommand. 

Operator response
 The file transfer must be started again from
the beginning. If you continue to  experience this error, report the
error to the system programmer. 

System programmer response
 Most servers do not require an SBSENDEOL
setting other than the default,  CRLF.    If SBSENDEOL is coded as
a different value in FTP.DATA  or you use the LOCSITE subcommand to
set the value to anything  other than CRLF,  users will not be able
to issue an SRESTART PUT command to restart a file transfer in  stream
mode.   If your users require the alternate SBSENDEOL value for only
certain servers,  specify SBSENDEOL CRLF in the client FTP.DATA data
set and instruct the users to issue the LOCSITE SBSENDEOL subcommand
only after logging in to those servers to allow the users to restart
outbound stream mode file transfers to the servers that do not require
the alternate SBSENDEOL value.
 Consider whether block or compressed
mode file transfers would be  appropriate for your installation. 
Block and compressed mode transfers can be  restarted if you initiated
checkpointing before the file transfer.  See  the information about
 restarting a failed data transfer in z/OS Communications Server: IP User's Guide and
Commands.

Module
 EZAFTPCB

Procedure name
  None.