EZZ4205I

Explanation
 This TCP/IP or Telnet  could not be started because
one was already started with the same name, the maximum number of
eight TCP/IPs or Telnets were already started, or a TCP/IP is already
active in an INET configuration.
 proc is
the procedure that could not initialize.  It is either TCPIP or Telnet.
 jobname is
the jobname associated with the procedure used to start TCP/IP or
Telnet.
 reason will be one of the following: TCPIP ALREADY EXISTS
A TCP/IP with this jobname was already started on this system.
TELNET ALREADY EXISTS
TELNET with this jobname was already started on this system.
MAXIMUM OF 8 TCPIPS ALREADY STARTED
The maximum number of TCP/IPs have already been started on this
system.
MAXIMUM OF 8 TELNETS ALREADY STARTED
The maximum number of Telnets have already been started on this
system.
TCPIP ALREADY ACTIVE IN INET CONFIGURATION
A TCP/IP is already active.  Only one TCP/IP can be active in
an INET configuration. 

System action
 This TCP/IP or Telnet failed to initialize.

Operator response
 Determine if the correct TCP/IP or Telnet
jobname was used to start TCP/IP or Telnet.

System programmer response
 Take the action  based on the specific
failure explanation.  The system programmer should either verify unique
TCP/IP or Telnet jobnames,  verify that eight or less TCP/IPs or Telnets
have been started, or verify that common inet is properly coded in
BPXPRMxx if a multiple stack environment is desirable.

Module
 EZBITINI