EZY1912I

MVP Diag7C Initiate-Accept followed by Status not supported.
Explanation
 The module responsible for providing the simulation
of the Logical Device Support Facility (LDSF) received an Initiate
request with a parameter list specifying that an Initiate-Accept followed
by a Status should be performed. This capability is not supported
by the simulation facilities present in the MVS™ platform code.

System action
 The invocation of MVPDG7C is terminated immediately
after issuing the message, and control is returned to the calling
Telnet server module (TNLDSFP) with a condition code of 3 and an error
reason code of 3. The Telnet server module subsequently fails the
Initiate request that it was processing at the time of the error.

Operator response
 Tell the system programmer about the error.

System programmer response
 Because specification of this processing
sequence depends on the value passed in the high-order byte of the
second input parameter, a programming error in the calling module
is the most probable cause. Corruption of the parameter list passed
to the LDSF simulation routine is also a possible cause. Gather all
available supporting documentation, and contact the IBM® Software Support Center.

Module
 MVPDG7C

Procedure name
  FINIT