After you have the Cross-Zone Requisite SYSMOD report, you can install the missing SYSMODs in the zones where they are needed. Follow these steps:

1. Receive any SYSMODs that have not yet been received into the appropriate global zone.
2. Install the SYSMODs in the zones where they are needed. If you have the SMPPUNCH output from the REPORT CROSSZONE command, you can use that. If the zones were defined in different global zones, SMPCSI and SMPCNTL DD statements would have been generated in the SMPPUNCH output. These DD statements must be copied to your job before the SMPPUNCH can be used.
3. Rerun the REPORT command using the same set of zones to check the results of installing the new SYSMODs.
4. Receive and install any additional SYSMODs that are needed.

For the example in this topic where all four zones are defined in the same global zone, follow these steps for ZONESET ZONEA and ZONESET ZONEX, because both contain zone PRODXYZ. You can continue to run the REPORT CROSSZONE command and install SYSMODs until all the needed SYSMODs have been installed in both ZONESETs.

For the example in this chapter where the zones are defined in two different global zones, follow these steps for ZONESET ZONEA and PRODXYZ, and also for ZONESET ZONEX and PRODABC because both contain zone PRODXYZ. You can continue to run the REPORT CROSSZONE command and install SYSMODs until all the needed SYSMODs have been installed in the required zones.