There may be times when you want to update only certain products on your system with the SYSMODs contained on a service tape. Assume you want to install all PTFs for a particular product to your system. This can be accomplished by specifying the following commands:

   SET      BDY(ZOSTGT1).
   APPLY    PTFS
            FORFMID(HOP0001).

or

   SET      BDY(ZOSTGT1).
   APPLY    FORFMID(HOP0001).

In both cases, SMP/E applies all applicable PTFs for the product with FMID HOP0001 to target zone ZOSTGT1. Unless you specify otherwise, PTFS is the default SYSMOD type.