The SMPJCLIN data set contains a job stream of assembly, link-edit,
and copy job steps. This data is typically the stage 1 output from
the most recent full or partial system generation, but it may be other
data in a similar format, such as output from the SMP/E GENERATE command.
This job stream is used as input to the JCLIN command to update or
create entries in a target zone.
Attributes
Sequential; LRECL=80, BLKSIZE=multiple of 80, RECFM=FB.
Device
Card, tape, direct access, or terminal.
Note:
BLKSIZE must not exceed 32760.
This data set may reside in a UNIX file
system. Specify PATHOPTS(ORDONLY) and either FILEDATA=TEXT or FILEDATA=BINARY on the DD statement
if it is to reside in a UNIX file
system. For simplicity, FILEDATA=TEXT is preferred,
and ensure the newline character (X'15') marks the
end of each line. If you use FILEDATA=BINARY, you
must ensure that each line is padded with blanks to the 80-byte record
length because there is no end of record marker in binary data.