SMP/E for z/OS Commands
Previous topic | Next topic | Contents | Contact z/OS | Library | PDF


Data sets used

SMP/E for z/OS Commands
SA23-2275-01

The following data sets might be needed to run the ZONEIMPORT command. They can be defined by DD statements or, usually, by DDDEF entries. For more information about these data sets, see SMP/E for z/OS Reference.
Note:
  1. zone represents the DD statements required for each distribution zone or target zone referred to in this command. If the DD statements are not specified, the data sets are dynamically allocated according to the ZONEINDEX information in the GLOBALZONE entry. Also note that, while DD statements may be used to override the ZONEINDEX information, they are not a substitute for a zoneindex. A zoneindex is always required for a zone.
  2. infile represents the DD statement required for the input data set. It is pointed to by the INFILE operand.
Parent topic: The ZONEIMPORT command

Go to the previous page Go to the next page

Notices | Terms of use | Support | Contact z/OS | zFavorites



Copyright IBM Corporation 1990, 2014