SMP/E for z/OS Commands
Previous topic | Next topic | Contents | Contact z/OS | Library | PDF


Data sets used

SMP/E for z/OS Commands
SA23-2275-01

The following data sets might be needed to run the LINK MODULE command. They can be defined by DD statements or, preferably, by DDDEF entries. For more information about these data sets, see SMP/E for z/OS Reference.
Note:
  1. The SMPLTS data set is required only if a load module with CALLLIBS subentries is specified on the INTOLMOD operand of the LINK MODULE command.
  2. Distribution library represents the DD statements required for each distribution library required to provide modules for the link-edits.
  3. Target library represents the DD statements required for each target library required to provide modules or load modules for the link-edits.
  4. zone represents the DD statements required for each distribution zone or target zone used by this command. If the DD statements are not specified, the data sets are dynamically allocated using the ZONEINDEX information in the GLOBALZONE entry. Also note that, while DD statements may be used to override the ZONEINDEX information, they are not a substitute for a zoneindex. A zoneindex is always required for a zone.
  5. SMPPARM is required only if exit routines have been defined in SMPPARM member GIMEXITS.
Parent topic: The LINK MODULE command

Go to the previous page Go to the next page

Notices | Terms of use | Support | Contact z/OS | zFavorites



Copyright IBM Corporation 1990, 2014