Operands

COMPAREDTO: specifies the zone (called the comparison zone) that SMP/E should compare against the input zone for SYSMOD content. You can specify a single target zone or distribution zone name. In addition, a global zone CSI data set and zone name can be specified if the comparison zone is defined in a different global zone. The COMPAREDTO zone must not be the same as the zone specified on the INZONE operand. A report is issued to indicate which SYSMODs were in the input zone but not in the comparison zone.
COMPAREDTO is a required operand on the REPORT SYSMODS command.
Note: COMPAREDTO is allowed only on the REPORT SYSMODS command.
INZONE: specifies the input zone that SMP/E should use to compare against another zone (called the comparison zone) for SYSMOD content. You can specify a single target zone or distribution zone name. This must not be the same as the zone specified on the COMPAREDTO zone. A report is issued to indicate which SYSMODs were in the input zone but not in the comparison zone.
INZONE is a required operand on the REPORT SYSMODS command.
Note: INZONE is allowed only on the REPORT SYSMODS command.
NOPUNCH: indicates that SMP/E should not write any output to SMPPUNCH. If NOPUNCH is not specified, JCL or commands are written to SMPPUNCH. This output contains JCL or commands that can be used for further processing.
Note: The output produced by REPORT SYSMODS processing contains commands for installing SYSMODs from the input zone that are applicable to the comparison zone.
SYSMODS: requests a report comparing the SYSMOD content of two zones.
SYSMODS is a required operand for the REPORT SYSMODS command.
Note: SYSMODS is mutually exclusive with CALLLIBS, CROSSZONE, SOURCEID, and ERRSYSMODS.