Operands

NOPUNCH

indicates that SMP/E should not write any output to SMPPUNCH. If NOPUNCH is not specified, JCL or commands are written to SMPPUNCH. This output contains JCL or commands that can be used for further processing.

Note: The output produced by REPORT SOURCEID processing contains commands for listing SYSMODs associated with the source IDs that were found in the specified zones.

SOURCEID

requests a report listing all the source IDs assigned to SYSMODs in a given zone or ZONESET.

SOURCEID is a required operand for the REPORT SOURCEID command.

Note: SOURCEID is mutually exclusive with CALLLIBS, CROSSZONE, ERRSYSMODS, and SYSMODS.

SYSMODIDS

indicates that in the SOURCEID report, SMP/E should also include the IDs of the SYSMODs to which each source ID is assigned.

If SYSMODIDS is not specified, the SOURCEID report contains the source IDS assigned to SYSMODs in the zones being reported on, but not the SYSMOD IDs associated with those source IDS.

Note: SYSMODIDS is allowed only on the REPORT SOURCEID command.

ZONES

specifies which zones SMP/E should report on. This list can include zone names, ZONESET names, or both. You can specify the global zone, target zones, distribution zones, or any combination of these. SMP/E produces a separate report for each zone it checks.

For each specified value, SMP/E first checks for a ZONESET with the same name. If none is found, SMP/E checks for a zone with the same name. For example, suppose you have a ZONESET named ZOSZSET and a zone named ZOSZSET. If you specify ZOSZSET on this operand, SMP/E assumes you want to use the zones defined in ZONESET ZOSZSET (which might or might not include zone ZOSZSET), and not the individual zone ZOSZSET.

ZONES is a required operand on the REPORT SOURCEID command.