If you use the REPORT CROSSZONE command, keep these considerations
in mind:
- After installing the requisite SYSMODs identified by the REPORT
CROSSZONE command, you should run the command again to see whether
that installation causes any new requisites. You should repeat this
process until there are no new requisites.
- You should always check the Cross-Zone Requisite SYSMOD report
for unreceived requisites before using the SMPPUNCH output from REPORT
CROSSZONE. You may want to receive these SYSMODs in order to run the
commands in SMPPUNCH, or you may prefer to delete them from SMPPUNCH
and receive them later.