SMP/E for z/OS Messages, Codes, and Diagnosis
Previous topic | Next topic | Contents | Contact z/OS | Library | PDF


Using the DEBUG command

SMP/E for z/OS Messages, Codes, and Diagnosis
GA32-0883-01

The DEBUG command helps you to collect diagnostic information. If you are experiencing a problem with an SMP/E command, the IBM® Support Center may ask you to use the SMP/E DEBUG command to gather more information about the problem. The DEBUG command is used with other SMP/E commands to:
  • Obtain dumps of SMP/E storage
  • Obtain dumps of VSAM RPL control blocks
  • Trace the source of SMP/E messages
  • Retain temporary work directories

These uses of the DEBUG command are described later in this topic.

Parent topic: Collecting documentation for SMP/E problems

Go to the previous page Go to the next page

Notices | Terms of use | Support | Contact z/OS | zFavorites



Copyright IBM Corporation 1990, 2014