Explanation: AGE is an optional subparameter
of SELECT, specifying a list of entries for those data sets in the
MCDS that have been referred to within the specified range of days.
AGE is also used for those data sets in the BCDS that have been backed
up within the specified range of days. The values to specify when
using the AGE parameter are explained:
- mindays
- specifies the minimum number of days since the data sets have
been referred to or backed up.For mindays, substitute a decimal
number from 0 to 999999.
- maxdays
- specifies the maximum number of days since the data sets have
been referred to or backed up. Specify a maxdays value greater
than or equal to the mindays value. For maxdays,
substitute a decimal number from 0 to 999999.
Defaults: The default for mindays is
0. The default for maxdays is 999999. The default range
causes entries to be listed for all data sets that meet the data set
or volume-selection criteria. If maxdays is less than mindays, maxdays defaults to the same value as mindays.
Note: - AGE applies to information from the MCDS and BCDS.