Explanation: ALL, BACKUPCONTROLDATASET, MIGRATIONCONTROLDATASET,
and OFFLINECONTROLDATASET are mutually exclusive parameters that
you use to audit sources of data set names, such as all control data
sets or a specific control data set. Each of these represents a source
of data set names.
ALL is specified to audit the migration control
data set, the backup control data set, and the offline control data
set. ALL is not used to audit the common queues.
BACKUPCONTROLDATASET is specified to audit
the DFSMShsm backup control data set.
MIGRATIONCONTROLDATASET is specified to audit
the DFSMShsm migration control data set.
OFFLINECONTROLDATASET is specified to audit
the DFSMShsm offline control data set. The TTOC records are the source
of information to determine which data sets are audited. DAILY | ML2
| SPILL | ALL are mutually exclusive, optional subparameters of the
OFFLINECONTROLDATASET parameter used to specify which tape volumes
to audit.
| Subparameter |
Explanation |
|---|
| DAILY |
OFFLINECONTROLDATASET(DAILY
) is specified to audit tape daily backup volumes. For DAILY(day), substitute a decimal number from 1 to 31 to represent the
day in the backup cycle. If you do not specify a particular day, the
audit output occurs in the following order:
- All volumes assigned to day 1
- All volumes assigned to day 2
- And so forth, until all tape daily backup volumes have been audited
For each day, the order of the audit output is in ascending volume
serial number sequence. |
| ML2 |
OFFLINECONTROLDATASET(ML2) is specified to audit all tape migration level 2 volumes. The
order of audit output occurs in ascending volume serial number sequence
for migration level 2 volumes. |
| SPILL |
OFFLINECONTROLDATASET(SPILL) is specified to audit all tape spill backup volumes. The order
of audit output occurs in ascending volume serial number sequence
for spill volumes. |
| ALL |
OFFLINECONTROLDATASET(ALL) is
specified to audit all tape volumes. The audit output occurs in the
following order:
- All daily backup volumes. The daily backup volumes are listed
for each day, and the volumes assigned to each day are listed in ascending
volume serial number sequence.
- All spill backup volumes. The spill backup volumes are listed
in ascending volume serial number sequence.
- All unassigned backup volumes. The unassigned backup volumes
are listed in ascending volume serial number sequence.
- All migration level 2 volumes. The migration level 2 volumes
are listed in ascending volume serial number sequence.
|
Note: - When you request an audit of the MCDS or BCDS, DFSMShsm uses the
VTOC of the primary volumes to ensure that the volume specified in
the catalog contains the data set referred to. Therefore, those primary
volumes (including those managed by SMS) must be mounted.
- If you specify the OFFLINECONTROLDATASET parameter without a subparameter,
the AUDIT command fails.
- Dump volumes are not audited.