Use the following steps to perform an ICKDSF repair on a PPRC-managed primary volume:
- Suspend the volume pair with a CSUSPEND PRIMARY command that is
directed to the primary volume. This assumes that the volume pairs
are not already in a suspended state as a result of the error that
necessitated the ICKDSF repair action.
- Run the latest level of ICKDSF to correct the error once the pair
is in the suspended state.
- Remove the volumes from the suspended state by using the CESTPAIR
command with the RESYNC option to resume operations.
For additional information about specific error conditions, refer
to Putting PPRC error recovery procedures into effect.