Optional parameters

HLQ(hlq): Specifies the name of the high-level qualifier for the state, control, and journal data sets to which the XCOUPLE command refers. The XCOUPLE HLQ name must be from one to eight characters, and can be any name acceptable to TSO. SYS1 is the default value. HLQ is only valid with the XCOUPLE PURGE command.
MHLQ(mhlq): Specifies the high-level qualifier of the master session control data set. The default is SYS1. MHLQ is only valid with the XCOUPLE ADD and XCOUPLE PURGE commands. It is not a valid option for the XCOUPLE DELETE command.
MSGROUTEID: Specifies the user ID to which XRC messages that are associated with the processing of this command are routed. If the specified user ID is not logged on, TSO saves messages in the TSO BRODCAST data set and displays them after the next logon.
Note: Messages issued by the initial command parser routine are sent to the user ID that issues the TSO command.
NOVERIFY: Specifies that XRC not issue message ANTT0025A, which prompts the user to confirm that XRC should continue to process the command. If you select this option, XRC immediately processes the command without waiting for verification.