IBM® suggests that you use
the following common invocation parameters:
- For ANTRQST macro invocation, specify the following common parameters:
ANTRQST ILK=ilk-value,REQUEST=request,MF=(E,listname,attribute)
- For ANTRQSTL macro invocation with ILK=VERSION1, specify the following
common parameters:
ANTRQSTL MF=(L, listname)
Note: The specified listname on the ANTRQSTL macro
must be the same listname that is used on the ANTRQST macro.
- For ANTRQSTL macro invocation with ILK=VERSION2 (the default),
specify the following common parameters:
ANTRQSTL
NAME=parameter_list_name, X
BASE=base_value, X
ILK=ilk_value, X
GENCODES=YES|NO, X
GENPLIST=YES|NO
Where:
- NAME
- Specifies the name of the generated parameter list and the prefix
of the variables used by ANTRQST. The default is PLIST.
Example:
If you code
NAME=PARM_LIST, the following definition
is generated.
PARM_LIST DS 0D
ANTRQST macro
uses the same name parameter,
NAME=PARM_LIST, thus
the following definition is generated.
ANTRQST ... X
... X
MF=(E,PARM_LIST)
- BASE
- Specifies the alignment of the generated parameter list. The
valid values are 0D and 0F. The default is 0D.
Example: If you
code
BASE=0F, the following definition is generated.
PLIST DS 0F
- ILK
- Specifies what version of the parameter list to generate. The
valid values are VERSION1 and VERSION2. The default is VERSION2.
Note: If you code VERSION1, you must also code it on the ANTRQST
macro. Similarly, if you code VERSION1 for ILK on the ANTRQST macro,
you must also code it on the ANTRQSTL macro.
- GENCODES
- Specifies whether or not to generate the definitions of the return
codes. The valid values are YES and NO. The default is YES.
- GENPLIST
- Specifies whether or not to generate an ANTRQST parameter list.
The valid values are YES and NO. The default is YES.