CDELPATH – deleting paths

Use the CDELPATH command to delete all established paths between a primary site (source) logical subsystem and a recovery site (target) logical subsystem. Only active paths between the specified logical subsystems are affected; all other paths to other subsystems are unaffected.

Note:

Before issuing a CDELPATH command, issue a CDELPAIR command to all active PPRC volume pairs. The CDELPATH command might cause the issuance of an ANTP0121I message if you do not follow this sequence.
You can use the CESTPATH command to remove only selected paths. Each time you issue a CESTPATH command, the paths specified on it replace the paths that are established by the last CESTPATH command that was issued. This feature should be used with caution.

For additional information about deleting paths and a CLIST example, refer to Deleting PPRC paths.

For additional information about removing paths, refer to the note under CESTPATH – establishing paths.