You can administer multiple virtual portals by running
a single configuration command. The following configuration tasks
support working with multiple virtual portals: create-virtual-portal, delete-virtual-portal, and modify-virtual-portal. Use the -DvirtualPortalList parameter with
task to create, delete, or modify multiple virtual portals at the
same time.
About this task
Specify the virtual portal property sets in the file wkplc.properties that is used with the configuration
tasks. When you run the configuration task, you pass the list of virtual
portals by using the parameter -DvirtualPortalList.
Here is an example for creating two virtual portals:
Procedure
- Specify the two virtual portal property sets in the file wkplc.properties as follows:
vp1.VirtualPortalTitle=vp1
vp1.VirtualPortalRealm=
vp1.VirtualPortalHostName=
vp1.VirtualPortalContext=vp1
vp1.VirtualPortalNlsFile=
vp2.VirtualPortalTitle=vp2
vp2.VirtualPortalRealm=
vp2.VirtualPortalHostName=
vp2.VirtualPortalContext=vp2
vp2.VirtualPortalNlsFile=
Specify
the realms and host names only if your portal has multiple realms.
- To create both virtual portals by using a single configuration
command, use the parameter -DvirtualPortalList to specify the two portals vp1 and vp2:
ConfigEngine create-virtual-portal -DvirtualPortalList=vp1,vp2
- For IBM® i: ConfigEngine.sh create-virtual-portal -DvirtualPortalList=vp1,vp2
- For Linux: ConfigEngine.sh create-virtual-portal -DvirtualPortalList=vp1,vp2
- For Windows: ConfigEngine.bat create-virtual-portal
-DvirtualPortalList=vp1,vp2