CREATE WEBSERVICE

Define a WEBSERVICE resource in the local CICS region.

CREATE WEBSERVICE

CREATE WEBSERVICE attribute values

Conditions: INVREQ, LENGERR, NOTAUTH

Note to COBOL programmers: In the syntax above, you must use ATTRIBUTES(data-area) instead of ATTRIBUTES(data-value).

Description

The CREATE WEBSERVICE command installs a WEBSERVICE resource definition with the attributes specified on the command. It does not use a resource definition stored in the CSD. If a WEBSERVICE resource exists with the name you specify in the local CICS region, the new definition replaces the old one; if not, the new definition is added.

A sync point is implicit in CREATE WEBSERVICE processing, except when an exception condition is detected early in processing the command. Uncommitted changes to recoverable resources made up to that point in the task are committed if the CREATE executes successfully, and rolled back if not. See Creating resource definitions for other general rules governing CREATE commands.

Options

ATTRIBUTES(data-value)

Specifies the attributes of the WEBSERVICE resource being added. The list of attributes must be coded as a single character string. See The ATTRIBUTES option for general rules for specifying attributes, and WEBSERVICE attributes for details about coding a character string for specific attributes.

ATTRLEN(data-value)

Specifies the length in bytes of the character string supplied in the ATTRIBUTES option, as a halfword binary value. The length may not exceed 32767 bytes.

LOGMESSAGE(cvda)

Specifies whether CICS logs the attributes used for the resource that is created. CVDA values are as follows:

LOG: The resource attributes are logged to the CSDL transient data queue.
NOLOG: The resource attributes are not logged.

WEBSERVICE(data-value)

Specifies the 8-character name of the WEBSERVICE resource definition to be added to the CICS region.

Conditions

INVREQ

RESP2 values:

n: There is a syntax error in the ATTRIBUTES string, or an error occurred during either the discard or resource definition phase of the processing. The RESP2 value is associated with a message written to the transient data queue CSMT which identifies more precisely the nature of the error. See RESP2 values for EXEC CICS CREATE and EXEC CICS CSD commands for information on RESP2 values.
200: The command was executed in a program defined with an EXECUTIONSET value of DPLSUBSET or a program invoked from a remote system by a distributed program link without the SYNCONRETURN option.
612: Installation of this WEBSERVICE resource failed because it already exists

LENGERR

RESP2 values:

1: The length you have specified in ATTRLEN is negative.

NOTAUTH

RESP2 values:

100: The user associated with the issuing task is not authorized to use this command.