CREATE MAPSET
Define a map set in the local CICS region.
Conditions: ILLOGIC, INVREQ, LENGERR, NOTAUTH
Description
The CREATE MAPSET command installs a MAPSET definition with the attribute specified on the command. It does not use a resource definition stored in the CSD. Map set names must be unique among map set, program, and partition set names within a CICS region. If the local region already has one of these resources with the name you specify, the new definition replaces the old one; if not, the new definition is added.
A syncpoint is implicit in CREATE MAPSET processing, except when an exception condition is detected early in processing the command. Uncommitted changes to recoverable resources made up to that point in the task are committed if the CREATE executes successfully, and rolled back if not. See Creating resource definitions for other general rules governing CREATE commands.
Options
- ATTRIBUTES(data-value)
- Specifies
the attributes of the MAPSET being added. The list of attributes must
be coded as a single character string using the syntax shown in MAPSET
attributes. See The ATTRIBUTES option for
general rules for specifying attributes, and MAPSET definition
attributes for
details about specific attributes. Note: You can assign default values for all attributes of a MAPSET definition by specifying an ATTRLEN value of 0. You still need to specify the ATTRIBUTES option, however, even though its value is not used.
- ATTRLEN(data-value)
- Specifies the length in bytes of the character string supplied in the ATTRIBUTES option, as a halfword binary value. The length can be from 0 to 32 767.
- LOGMESSAGE(cvda)
- Specifies whether CICS logs the attributes used for the resource that
is created. CVDA values are as follows:
- LOG
- The resource attributes are logged to the CSDL transient data queue.
- NOLOG
- The resource attributes are not logged.
- MAPSET(data-value)
- specifies the 8-character name of the MAPSET definition to be added to the CICS region.
Conditions
- ILLOGIC
- RESP2 values:
- 2
- The command cannot be executed because an earlier CONNECTION or TERMINAL pool definition has not yet been completed.
- INVREQ
- RESP2 values:
- n
- There is a syntax error in the ATTRIBUTES string, or an error occurred during either the discard or resource definition phase of the processing. See RESP2 values for EXEC CICS CREATE and EXEC CICS CSD commands for information on RESP2 values.
- 7
- The LOGMESSAGE cvda value is not valid.
- 200
- The command was executed in a program defined with an EXECUTIONSET value of DPLSUBSET or a program invoked from a remote system by a distributed program link without the SYNCONRETURN option.
- LENGERR
- RESP2 values:
- 1
- The length you have specified in ATTRLEN is negative.
- NOTAUTH
- RESP2 values:
- 100
- The user associated with the issuing task is not authorized to use this command.
- 101
- The user associated with the issuing task is not authorized to create a MAPSET definition with this name.