CREATE DB2CONN
Define a DB2CONN in the local system.
Conditions: ILLOGIC, INVREQ, LENGERR, NOTAUTH
Note to COBOL programmers: In
the syntax above, you must use ATTRIBUTES(data-area) instead
of ATTRIBUTES(data-value).
Description
The CREATE DB2CONN command installs a DB2CONN definition with the attribute specified on the command. It does not use a resource definition stored in the CSD. If there is already a DB2CONN in the local CICS region, the new definition replaces the old one; if not, the new definition is added.
A sync point is implicit in CREATE DB2CONN processing, except when an exception condition is detected early in processing the command. Uncommitted changes to recoverable resources made up to that point in the task are committed if the CREATE executes successfully, and rolled back if not.
Options
- ATTRIBUTES(data-value)
- Specifies the attributes of the DB2CONN that is being added. The
list of attributes must be coded as a single character string using
the syntax shown in DB2CONN attributes. See The ATTRIBUTES option for general rules for
specifying attributes, and DB2CONN attributes for
details about specific attributes. Note: You can assign default values for all attributes of a DB2CONN definition by specifying an ATTRLEN value of 0. You still need to specify the ATTRIBUTES option, however, even though its value is not used.
- ATTRLEN(data-value)
- Specifies the length in bytes of the character string supplied in the ATTRIBUTES option, as a halfword binary value. The length can be from 0 to 32767.
- DB2CONN(data-value)
- Specifies the 8-character name of the DB2CONN definition to be added to the CICS region.
- LOGMESSAGE(cvda)
- Specifies whether CICS logs the attributes used for the resource that
is created. CVDA values are as follows:
- LOG
- The resource attributes are logged to the CSDL transient data queue.
- NOLOG
- The resource attributes are not logged.
Conditions
- ILLOGIC
- RESP2 values:
- 2
- The command cannot be executed because an earlier CONNECTION or TERMINAL pool definition has not yet been completed.
- INVREQ
- RESP2 values:
- n
- A syntax error occurred in the ATTRIBUTES string, or an error occurred during either the discard or resource definition phase of the processing. See RESP2 values for EXEC CICS CREATE and EXEC CICS CSD commands for information about RESP2 values.
- 7
- The LOGMESSAGE CVDA value is not valid.
- 200
- The command was executed in a program defined with an EXECUTIONSET value of DPLSUBSET or a program invoked from a remote system by a distributed program link without the SYNCONRETURN option.
- LENGERR
- RESP2 values:
- 1
- The length you have specified in ATTRLEN is negative.
- NOTAUTH
- RESP2 values:
- 100
- The user associated with the issuing task is not authorized to use this command.
- 102
- The user associated with the issuing task is not an authorized surrogate of the user specified in the AUTHID, COMAUTHID, or SIGNID parameter.
- 103
- The user associated with the issuing task is not authorized to create a DB2CONN with an AUTHTYPE or COMAUTHTYPE parameter.