If you are using IBM® Rational® Integration Tester to
run a stub, you can modify the stub while it is running.
About this task
Note: If you are using
Rational Integration Tester 8.0.1
(or later), clicking default case console output or failed validation
console output on the Test Lab perspective’s Console window opens
the Message Differences window, which enables you to debug the stub.
(For information about debugging a stub, refer to Debugging Message-Based
Stubs. For general information about the Message Differences window,
refer to
Rational Integration Tester reference.)
To modify a running stub:
Procedure
- In Rational Integration Tester’s
Test Factory perspective, double-click the stub to open it in the
Stub Editor.
- Use the Stub Editor to make and save any
required changes to the stub. (For information about using the Stub
Editor, refer to Modifying message-based stubs.)
- Open the Test Lab perspective.
Results
The Task Monitor window shows that the modified
stub was stopped and restarted by Rational Integration Tester.