cleanupNode command

The cleanupNode command cleans up a node configuration from the cell repository.

Only use this command to clean up a node if you have a node defined in the cell configuration, but the node no longer exists. For more information about where to run this command, see Using command tools.

Syntax

The command syntax is as follows:

cleanupNode <node name> [deploymgr host] [deploymgr port] [options]

where the first argument is required.

Parameters

The following options are available for the cleanupNode command:

-quiet: Suppresses the progress information that the cleanupNode command prints in normal mode.
-trace: Generates trace information into a log file for debugging purposes.
-profileName: Specifies the deployment manager profile to run the command against. This parameter must be specified if the default profile is not a deployment manager profile.

Usage scenario

The following examples demonstrate correct syntax:

cleanupNode myNode -profileName dmgr 

cleanupNode myNode -trace -profileName mydmgr