You might need to install an expansion unit into
the rack. Use the procedure in this section to perform this task.
This procedure assumes that you are installing the model
5088 or the
0588
expansion unit into an existing rack. If the rack is not installed, go to
the instructions for
Install
the rack. and then return to this procedure for instructions on installing
the expansion unit into the rack.
Note: This procedure applies only to the
models that are designed to be mounted in a rack. Do not attempt to install
a stand-alone model in a rack.
To install the 5088 or
the 0588 expansion
unit into a rack, complete the following steps:
CAUTION:
Installing
the rails in the rack is a complex procedure. To install the rails correctly,
you must perform each task in the following order. Failure to do so might
cause rail failure and potential danger to yourself and the system unit.