To migrate an IBM® i mobile
partition from the source server to the destination server, verify
that the IBM i partition
is in the restricted I/O mode.
You must be a super administrator to do this task.
To verify that the IBM i mobile partition
is in the restricted I/O mode, complete the following steps by using
the Hardware Management Console (HMC):
- In the navigation pane, open Systems Management and
select Servers.
- Click the managed system on which the mobile partition
is located.
- In the work pane, select the mobile partition.
- From the Tasks menu, click Properties.
- Verify the following information in the General tab.
The HMC Classic interface is
not supported in Hardware Management Console (HMC) Version 8.7.0, or later. The functions that were previously
available in the HMC Classic interface are now available in
the HMC Enhanced+ interface.
When the
HMC is at version 8.7.0, or later,
complete the following steps to verify that the
IBM i
mobile partition is in the restricted I/O mode:
- In the navigation pane, click the Resources icon .
- Click All Partitions. Alternatively, click All
Systems. In the work pane, click the server name that has the logical partition. Click
View System Partitions. The All Partitions page is displayed.
- In the work pane, select the logical partition and click .
- In the General Properties tab, click the Advanced
tab.
- If the Restricted IO Partition check box is selected, you can migrate the
IBM i mobile partition.
- If the Restricted IO Partition check box is cleared, you cannot migrate
the IBM i mobile partition. Complete the following
steps to migrate the IBM i mobile partition:
- Stop the mobile partition.
- Select the Restricted IO Partition check box.
- Restart the mobile partition.
- Click OK.