Installing the 7310-CR4 HMC into a rack
This section describes how to install the 7310-CR4 HMC into a rack. This is a customer task.
If an HMC is used to manage any POWER7® processor-based system, the HMC must be a CR3, or later, model rack-mounted HMC.
The following is a rear-view of the 7310–CR4:
Figure 1. Rear-view of the 7310–CR4
To install the 7310-CR4 HMC into a rack, complete the following steps:
- Complete a parts inventory. See Completing a parts inventory.
- Locate the rack-mounting hardware kit and the system rail assemblies that were included with your system unit.
Figure 2. Rail Kit
Sliding-rail kit parts |
---|
A Slide rails |
B Cable-management arm mounting plate |
C Cable-management arm |
D Cable-management bracket |
E Cable-management support bracket and security tab |
F Latch strikes (2) |
G Screws (6) |
Important: This system unit is 1 EIA unit high; you
will need this information to complete the installation.