When you use the Hardware Management Console (HMC) to change the IPL
type, the managed system loads the Licensed Internal Code and IBM® i from the location specified
by the IPL type. The IPL type is also known as the IPL source, because
each IPL type is associated with a different IPL source.
You can choose a separate IPL type for each IBM i logical partition.
Attention: Only use IPL type C under the direction of your service
representative. Severe data loss can occur with incorrect use of this
function.
To change the IBM i IPL
type of a logical partition using the HMC, follow these steps:
- In the navigation pane, open ,
and click the managed system on which the logical partition is located.
- In the work pane, select the logical partition, click the Tasks button,
and click Properties.
- Click Settings, set IPL Source to your
preference, and click OK.
The HMC Classic interface is
not supported in Hardware Management Console (HMC) Version 8.7.0, or later. The functions that were previously
available in the HMC Classic interface are now available in
the HMC Enhanced+ interface.
When the
HMC is at version 8.7.0, or later,
complete the following steps to change the
IBM i IPL type
of a logical partition:
- In the navigation pane, click the Resources icon .
- Click All Partitions. Alternatively, click All
Systems. In the work pane, click the server name that has the logical partition. Click
View System Partitions. The All Partitions page is displayed.
- In the work pane, select the logical partition and click .
- Click the General tab and set IPL
Source to your preference, and click OK.