IBM Support

IBM Security Guardium V10: How To Install GIM Client On Unix Server?

Technote (FAQ)


Question

How To Install Guardium GIM Client On Unix Server?

Cause

Step by step guide for installation Of GIM Client On Unix Server using Redhat 6 as an example.

Answer

Prerequisites

1- IP Address and "root" access for DB Server
2- IP Address of the Guardium Appliance (GIM Server)
3- Directory structure on the DB server on which the GIM installation is to happen
4- IBM Knowledge Center Link For "Installing the GIM client on a UNIX server"

Steps
1- Check the version and release of your Unix Server:

2- From the downloaded GIM bundle, point out the GIM Client Installer file suitable for the UNIX server:

3- Transfer the gim client installer to your unix server. Select BINARY transfer mode in case transfer is initiated from Windows Operating System:

4- Make the gim client installer file an executable:

5- Check the Perl version - The GIM client requires Perl version 5.8.x or 5.10.x to be installed:

6- Start installation using silent mode:

Example Command Usage : ./guard-bundle-GIM-10.0.0_r79963_trunk_1-rhel-6-linux-x86_64.gim.sh -- --dir /usr/local/guardium --sqlguardip 10.222.48.81 --tapip 10.51.239.22 --perl /usr/bin -q

More details on the install command can be found here.

7- Verification of successful installation on DB server:
“ps -ef | grep gim” AND “ps -ef | grep –i super”

8- Verification of successful installation from Guardium appliance's GUI:

At this moment, the GIM client is successfully installed on the unix server and is pointing to the Guardium Appliance (GIM Server).

Document information

More support for: IBM Security Guardium
Installation

Software version: 10.0, 10.0.1, 10.1

Operating system(s): AIX, HP-UX, Linux, Solaris

Software edition: All Editions

Reference #: 1991742

Modified date: 22 December 2016


Translate this page: