IBM Support

Local Node Parameters section contains incomplete information for the node.check parameter

Technote (troubleshooting)


In the Connect:Direct for Windows System Guide, in the Local Node Parameters section, the table that defines the parameters and defaults for the local node contains incomplete information for the node.check parameter. The value "A checks the node address only" is missing.

The table should list the following for node.check:

The level of node checking.
  • A checks the node address only.
  • B checks both the node address and the node name.
  • C checks the node name only.

Resolving the problem

The Connect:Direct for Windows System Guide will be updated with the correct information. All future versions of this guide will also contain the correct information.

Document information

More support for: Sterling Connect:Direct

Software version: 4.4, 4.4.1, 4.5, 4.5.1, 4.6

Operating system(s): Windows

Software edition: All Editions

Reference #: 1648482

Modified date: 05 September 2013

Translate this page: